Single-Leg Hip Thrust
What you'll gain
Builds hip extension strength that carries into sprinting, jumping, and stair climbing.
Exposes and corrects side to side glute strength differences.
Allows a longer glute range of motion than a floor bridge.
Step-by-Step Instructions
- 1
Sit on the floor with your upper back resting against the edge of a bench.
- 2
Plant one foot flat with the shin close to vertical and the knee bent about ninety degrees.
- 3
Raise the other leg and hold the hip and knee at roughly ninety degrees.
- 4
Brace your trunk and tuck your chin so the neck stays neutral.
- 5
Drive through the planted foot until your hips reach the height of your torso.
- 6
Lower under control until the hips are just above the floor, then repeat and switch sides.
Common Mistakes
Hyperextending the lower back or neck at lockout, which hides a shortfall in glute range.
Pushing with the elbows against the bench, which takes work away from the glutes.
Stopping short of full hip extension, so the glute never reaches a hard contraction.
Letting the pelvis rotate toward the free leg, which unloads the working side.
About This Exercise
The single leg hip thrust sets your upper back on a bench so the hips can travel below the level of the shoulders before extending. One foot stays planted with the shin close to vertical while the other leg is held with the hip and knee near ninety degrees. The gluteus maximus, medius, and minimus drive the lift, with the spinal erectors, hamstrings, quadriceps, and adductors supporting the position rather than leading it. For a product catalog this clip covers the loaded end of glute programming: hypertrophy blocks, unilateral strength progressions, and posterior chain sections of a training app. The bench-supported setup is visually distinct from a floor bridge, which matters when a library needs both patterns to be told apart at a glance.
Looking for an exercise animation collection for your app, coaching platform, or content workflow? MoveKit gives you consistent quality across every movement so your product feels cohesive from first launch through scale.
Build faster with related MoveKit resources
A bench-supported unilateral hip extension that drives one glute through a longer range than a floor bridge.
Need more than one animation?
Compare our packs to find the right fit, all with commercial licensing included.
Specifications
Built for
- Glute hypertrophy blocks in a strength training app.
- Unilateral progressions after a two leg hip thrust in a program builder.
- Athletic performance programs targeting hip extension power.
- Exercise demo cards where the bench setup must be shown clearly.
Muscles Worked
Details
License Includes
Explore these exercise collections
90/90 Hip Switches
$4.99A seated hip-mobility drill that rolls both knees from one 90/90 position to the mirrored side with the pelvis grounded.
B-Stance Hip Thrust
$4.99A hip thrust with one foot staggered forward as a kickstand so the rear working leg carries most of the load.
Bodyweight Deficit Reverse Lunge
$4.99A reverse lunge stepped off a low platform so the rear knee drops below the front foot, done with empty hands.
Single Leg Glute Bridge
$4.99A floor-based unilateral hip extension that loads one glute at a time while the free leg stays off the ground.
Walking Knee Hugs
$4.99A walking warm-up that hugs one knee to the chest on each step, opening the hips while challenging single-leg balance.
Worlds Greatest Stretch
$4.99A deep lunge with an upward torso rotation that combines a hip stretch with an opening chest movement.