Snatch-Grip High Pull
What you'll gain
Trains the transition from leg and hip extension into the arm pull.
Builds trap and upper back strength with heavy pulling loads.
Reinforces a close bar path without needing to catch the lift.
Step-by-Step Instructions
- 1
Take a wide snatch grip on the bar and set your feet at shoulder width with the toes turned out slightly.
- 2
Stand tall, brace your trunk and pull your shoulders back so the lats hold the bar close.
- 3
Dip into the power position by pushing the hips back and letting the bar slide down the thighs.
- 4
Drive through the whole foot and extend the knees and hips explosively.
- 5
Shrug the traps hard, then keep pulling so the elbows rise high and outside the bar.
- 6
Let the bar settle back down the thighs under control and reset for the next rep.
Common Mistakes
Using a clean-width grip, which changes the bar path and the muscle emphasis the lift is named for.
Bending the elbows before full extension, which cuts the hip drive and lowers the pull height.
Letting the bar swing away from the body, which turns the pull into an upright row.
Loading past the point where the elbows can finish high, which defeats the purpose of the variant.
About This Exercise
The snatch-grip high pull is a snatch pull with a continued arm pull on the end. You set a wide snatch grip, extend the hips and knees explosively from the power position, shrug hard, then keep pulling so the elbows travel high and outside while the bar stays against the body. It exists to train the timing between the lower-body extension and the arm pull, and it is loaded at roughly seventy to ninety percent of the best snatch so elbow height is not compromised. The traps take the target load, with the glutes, hamstrings, quadriceps, shoulders and upper back supporting. Shipped as an asset, this covers a request that keeps coming up from weightlifting and CrossFit program builders: a pull variant that shows the third-pull arm action rather than stopping at extension.
Looking for an exercise animation collection for your app, coaching platform, or content workflow? MoveKit gives you consistent quality across every movement so your product feels cohesive from first launch through scale.
Build faster with related MoveKit resources
Wide-grip barbell pull that finishes with an aggressive shrug and the elbows driven high and outside.
Need more than one animation?
Compare our packs to find the right fit, all with commercial licensing included.
Specifications
Built for
- Pull accessory slot in a weightlifting program builder.
- Teaching sequence for the third pull of the snatch.
- Barbell club and CrossFit exercise library entry.
- Coaching content on bar path and finishing elbow height.
Muscles Worked
Details
License Includes
Explore these exercise collections
Dumbbell Single Arm Upright Row
$4.99A standing one-arm vertical pull that leads with the elbow to load the side delts and upper traps.
Prone Y-T Raises
$4.99A floor scapular series that lifts both arms into a Y, then a T, to train the lower traps and rear delts.
Seated Barbell Military Press
$4.99A seated barbell overhead press from a racked start at the upper chest, targeting the shoulders with a vertical bar path.
Single-Arm Landmine Press
$4.99A one-arm press of a landmine-anchored barbell from the shoulder, following the bar's arc up and across the body.
Trap Bar Carry
$4.99A loaded walk inside a hexagonal trap bar, training grip, upper traps, and an upright trunk.
Trap Bar Shrug
$4.99Neutral grip shrug with a trap bar, loading the upper trapezius through straight scapular elevation.