What you'll gain
Loads the glutes and hamstrings without placing compressive load on the spine.
Teaches the hip hinge pattern that deadlifts and kettlebell swings depend on.
Keeps tension constant through the range, which suits higher rep volume work.
Step-by-Step Instructions
- 1
Attach a rope to the lowest setting on a cable stack and face away from the machine.
- 2
Straddle the cable, reach between your legs and take one rope end in each hand.
- 3
Walk forward until the cable is taut, then set your feet about shoulder width apart.
- 4
Push your hips back and hinge forward with a flat back until the rope passes behind your legs.
- 5
Drive the hips forward and squeeze the glutes to stand tall, keeping the arms straight.
- 6
Control the return as the cable pulls you back into the hinge, then repeat.
Common Mistakes
Bending the knees into a squat, which shifts the work from the glutes to the quadriceps.
Standing too close to the stack, which leaves no tension at the stretched position.
Pulling the rope with the arms, which turns a hip hinge into a row.
Arching the lower back at lockout instead of finishing with the glutes.
About This Exercise
The cable pull through is a hip hinge where the resistance comes from behind rather than from a bar on the back. A rope on the lowest pulley is held between the legs, and the lifter hinges until the torso is close to parallel before driving the hips forward to stand. Because the load line runs horizontally, the spine carries very little compressive force while the glutes and hamstrings still work through a full range. That combination makes it a common teaching tool for the hinge pattern and a high-volume glute exercise when heavier hinging is fatiguing. As an asset this clip is worth its place in any glute or posterior chain collection. It supports hinge-teaching sequences in app programs, cable machine equipment pages, and low back friendly alternatives inside programming decision trees.
Looking for an exercise animation collection for your app, coaching platform, or content workflow? MoveKit gives you consistent quality across every movement so your product feels cohesive from first launch through scale.
Build faster with related MoveKit resources
Cable Pull Through
A cable-loaded hip hinge that pulls resistance forward from between the legs, driving the glutes with little spinal load.
Need more than one animation?
Choose a focused 104-exercise pack or unlock all 412, with commercial licensing included.
Specifications
Built for
- Hinge pattern teaching sequences in training app programs.
- Glute focused accessory blocks and posterior chain collections.
- Cable machine equipment pages and filtered library browsing.
- Low back friendly substitutions inside programming decision trees.
Muscles Worked
Details
License Includes
Cable Bench Straight Leg Kickback
$4.99A bench-supported cable kickback that isolates the glutes with a straight-leg drive against constant cable tension.
Cable Hip Abduction
$4.99A standing cable exercise that lifts one straight leg out to the side, isolating the hip abductors.
Cable Kickback
$4.99Standing single leg hip extension against a low cable that isolates the glutes through a controlled range.
Standing Cable Hip Abduction
$4.99A standing cable isolation that lifts one leg out to the side against a low pulley to load the hip abductors.
B-Stance Hip Thrust
$4.99A hip thrust with one foot staggered forward as a kickstand so the rear working leg carries most of the load.
Band Glute Bridge
$4.99A floor glute bridge with a loop band above the knees, adding an abduction demand to ordinary hip extension.